How to Solve the Problem of Insufficient Pressure of Hydraulic Press MachineUpdate：2024-08-08 Hits：119
To solve the problem of insufficient pressure of the hydraulic press machine, you can start from the following aspects:First, check the oil pump. If the oil pump is worn or damaged, it should be replaced or repaired in time. For example, the blades of an oil pump are so worn that they cannot provide sufficient oil pressure.
Secondly, check the hydraulic valve. Check for leaks and replace seals or repair spools if any. For example, a leaking relief valve can cause the system pressure to not reach the set point.
Again, check the oil circuit. Make sure that the oil circuit is smooth and there is no blockage. Dirt accumulation inside the tubing like oil can hinder the flow of oil.
Attention should also be paid to the cylinders. Check the cylinder for internal leaks and repair or replace cylinder parts if so. For example, a failure of the cylinder's piston seal can cause the pressure to drop.
In addition, calibrate the pressure sensor and gauge to ensure that the pressure display is accurate.
Finally, check the quality and level of the hydraulic oil to ensure that it is clean and within the normal level range.
How to avoid insufficient pressure in a hydraulic press?
In order to avoid insufficient pressure of the hydraulic press, it must be carried out from the following three aspects:
1. In order to ensure the smooth oil flow of the oil pump, there is an appropriate amount of oil and enough pressure to maintain the normal operation of the system.
2. Ensure that the relief valve can be used normally to avoid blockage and damage.
3. Ensure that the oil volume in the fuel tank is sufficient to avoid problems such as system air absorption.
